![]() Interface IP-Address OK? Method Status Protocol In my example PC is 10.10.10.1/24 & AP is 10.10.10.102/24.Ĭonsole into the access point & do the following configurations. If you are powering AP from the switch (i.e use PoE) then PC & AP needs to be in two switch ports in the same vlan. To convert Lightweight AP to Autonomous AP, need to have PC directly connected to AP’s ethernet port. More specifically c1140- .tar as my AP is 1142. In our case we require k9w7 for Autonomous conversion. rcvk9w8 – lightweight recovery image – this is factory installed on lightweight APs, unless a “mesh” image is specified it lacks radio firmware.aes image, and is factory installed on “mesh” APs) k9w8 – full lightweight IOS (this is what is bundled in the WLC.I found following blog post is very useful to summarize the type of IOS & understanding its naming convention.įollowing are the three type of IOS available & need to download the correct type before starting the conversion process. ![]() Before converting LWAP to Autonomous need to understand the type of OS image running on these platforms. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |